Siemens Server User Manual
Server Setup
27
The entry box “Release value” specifies the value at which the event initiates the information
e-mail.
By clicking the selection box under “Activate”, the event is enabled.
The entries are stored by clicking “send data”. By clicking “close window”, the window is closed
without storing the entries.
If a connection to the Internet cannot be established after an event has occurred, the ChemWeb Server
will try it again every 5 minutes.
An e-mail due to an event is only released within a time frame of 5 minutes. Events which occur
earlier are deleted and cannot be recorded!
Time/date setting
e-mail.
By clicking the selection box under “Activate”, the event is enabled.
The entries are stored by clicking “send data”. By clicking “close window”, the window is closed
without storing the entries.
If a connection to the Internet cannot be established after an event has occurred, the ChemWeb Server
will try it again every 5 minutes.
An e-mail due to an event is only released within a time frame of 5 minutes. Events which occur
earlier are deleted and cannot be recorded!
Time/date setting
Under this menu item, the internal clock of the ChemWeb Server can be set. The data can be entered
manually or be imported from the PC clock by clicking “Fields sync to PC clock”. To confirm the
entry for the internal clock of the ChemWeb Server, click “Set webserver clock”.
manually or be imported from the PC clock by clicking “Fields sync to PC clock”. To confirm the
entry for the internal clock of the ChemWeb Server, click “Set webserver clock”.
If the power supply of the ChemWeb Server is switched off for more
than 2 days, the date and time setting must be checked after restart
and corrected if necessary!
Server commands
Connect ISP / Disconnect ISP:
Click this command to connect the ChemWeb Server manually to the Internet by using the data
from “ISP Configuration”. As soon as the connection has been established, the ChemWeb Server
creates an e-mail with the valid IP address which is sent to the receiver addresses set under “Mail
Configuration”. The ChemWeb Server can then be reached in the Internet via an assigned IP
address.
Click this command to connect the ChemWeb Server manually to the Internet by using the data
from “ISP Configuration”. As soon as the connection has been established, the ChemWeb Server
creates an e-mail with the valid IP address which is sent to the receiver addresses set under “Mail
Configuration”. The ChemWeb Server can then be reached in the Internet via an assigned IP
address.