Sharper Image Refrigerator KP-W140 User Manual

We recommend that you charge your Wine Preserver for at least 12 hours before 
using for the first time. Please follow the instructions for recharging as stated below: 
1) Charging your Wine Preserver

•  Plug end of the adaptor cord into the recharging base and the A/C end into an

electrical outlet.

•  Place the motorized wine preserver onto the charging base making sure that it is

firmly in position and that it is in full contact with the recharging connection. (Fig.1)

•  Press the power button once and a red light turns ON indicating that the unit is

charging. It will take approximately 8-10 hours to recharge your Wine Preserver.

•  When the wine preserver is fully charged, the LED light becomes green. (Fig.1)
 
2)  Date Dial
•  Press and hold for 0.5 second on the screen of the LCD date counter to start

the countdown.

•  The LCD initially shows “0” with a single increment every 24 hours.
•  It will automatically change to the 1st day after 24 hours and change to the 2nd

day after 48 hours and so on, up until the 9th day.

•  Press and hold for 0.5 second on the screen of the LCD date counter to turn off. 

Note: A 3V button cell battery comes pre-installed into the Date Dial. We
recommended that you always keep the date dial off while not in use for 
energy saving.

Battery Replacement
•  Unscrew the four screws from its end cap to remove its top cover as  

shown attached.

•  Take out the date counter module by releasing the snaps and replace  

the battery.

•  Use a single CR927 3V type battery per module only.

KP-W140_Wine Preserver wBase.ai   7/1/09   1:24:00 PM

5

4

Fig. 1

Wine Preserver

Charging Base

AC Adaptor

KP-W140_Stopper.ai   7/1/09   2:44:23 PM

Silicon Stopper (4)

LED Light

Date Dial

Power Button

Screws (4)