Serengeti Video Games SmartSync User Manual
SmartSync/DCP Installation Guide
13
TXLAT.EXE - Trace Translation Program
The TXLAT utility accepts 3780Link trace files as input and converts the
hexadecimal EBCDIC codes of these files into a more readable format.
TXLAT runs only from within a MS-DOS session. The DOS command line
syntax of TXLAT is:
hexadecimal EBCDIC codes of these files into a more readable format.
TXLAT runs only from within a MS-DOS session. The DOS command line
syntax of TXLAT is:
txlat [-b] [-x<file>] -i<file> -o<file>
-b
suppress translation of non-protocol trace characters
(use if binary data is expected)
(use if binary data is expected)
-x
specify an alternate translation table file (corresponds
to -x switch in 3780Link)
to -x switch in 3780Link)
-i
specify the input trace file
-o
specify the translated output file
AMXBSC.EXE
−−
SmartSync/DCP Download File
The “amxbsc.exe” file is downloaded to each SmartSync/DCP prior to
loading 3780Link by running the
loading 3780Link by running the
Dcpload
program that is described below.
A download need only be performed once before the first use of 3780Link.
IMPORTANT
This file is NOT an executable Windows program.
DCPLOAD
−−
SmartSync/DCP Download Utility
This program is used to initialize each SmartSync/DCP co-processor and
download the “amxbsc.exe” file. The “amxbsc.exe” file is expected to be
found in the current working directory. The optional command line switches
for
download the “amxbsc.exe” file. The “amxbsc.exe” file is expected to be
found in the current working directory. The optional command line switches
for
Dcpload
are described below:
-b
board
Specific board number to load [1-6]
The -b switch specifies which SmartSync/DCP
Dcpload
is to load. You must
indicate the board number, 1 through 6, as appropriate. The board number