Sennheiser DECT Comfort Calls DW Pro1/Pro2 User Manual
23
Using the headset system
When the battery is about to run flat ...
... only the LED segment 1 lights up weakly or flashes (see page 9).
... the HEADSET LED
flashes red.
... you hear a low battery warning (three beeps)in the headset.
... you have several minutes of battery reserve.
When the battery is flat, the headset switches off.
If the headset is outside the range of the base station, it will switch
off after 30 minutes in order to conserve battery power.
off after 30 minutes in order to conserve battery power.
Switching the headset on/off
If you place the headset into the base station, the headset automat-
ically switches to standby mode. In standby mode, the power
consumption is very low and the radiated power is reduced to a
minimum. The HEADSET LED
ically switches to standby mode. In standby mode, the power
consumption is very low and the radiated power is reduced to a
minimum. The HEADSET LED
lights up blue during charging.
Switching the headset on
4
5
왘
for 5 seconds.
The HEADSET LED
flashes blue 3 times and the wireless link to the
base station is established (where required). An ascending confirma-
tion beep is heard in the headset.
tion beep is heard in the headset.
Switching the headset off
왘
for 5 seconds.
Establishing a wireless link between headset and
base station
base station
To establish a wireless link between headset and base station:
4
5
왘
Press the LINK button
on the headset.
The link is established. The LINK LED
lights up blue and the
HEADSET LED
flashes blue.
To disconnect a wireless link between headset and base station:
왘
Press the LINK button
on the headset.
The link is disconnected. The LINK LED
and the HEADSET LED
go off.