Sennheiser EK 2000 IEM User Manual
13
Using the diversity receiver
Using the diversity receiver
To establish a transmission link, proceed as follows:
1. Switch the diversity receiver on (see next section).
2. Switch a transmitter on (see the instruction manual of the trans-
mitter).
The transmission link is established and the receiver’s RF level display
“
The transmission link is established and the receiver’s RF level display
“
RF
”
reacts.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter “Synchronizing a transmitter with the diversity
receiver” on page 28.
receiver, read the chapter “Synchronizing a transmitter with the diversity
receiver” on page 28.
Switching the diversity receiver on/off and adjusting
the volume
the volume
To switch the diversity receiver
on
:
왘
Turn the volume control
clockwise until it clicks.
The red
ON
LED
lights up. The “
Frequency/Name
” standard display
appears on the display panel.
To switch the diversity receiver
off
:
왘
Turn the volume control
counterclockwise until it clicks.
The red
ON
LED
It is vital to observe the notes on frequency selection on page 28.
쐏
�