Sennheiser EM 2050 User Manual
Using the receiver
13
Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see below).
2. Switch the transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the display backlighting of the receiver changes
from red to orange.
from red to orange.
If you cannot establish a transmission link between transmitter and receiver:
왘
Make sure that transmitter and receiver are set to the same frequency.
왘
If necessary, read the chapter “If a problem occurs ...” on page 31.
Switching the receiver on/off
To switch the receiver
on
:
To switch the receiver to
standby mode
:
왘
If necessary, deactivate the lock mode (see page 14).
To completely switch the receiver
off
:
왘
Disconnect the receiver from the mains by unplugging the mains cable plug from the wall
socket.
The backlighting of the
socket.
The backlighting of the
STANDBY
button
goes off.
Monitoring the audio signal via headphones
You can monitor the audio signal via the headphone output.
It is vital to observe the notes on frequency selection on page 29.
.200
UTE
MHz
**2000**
SKM2000
쐊
왘
Briefly press the
STANDBY
button
.
The receiver switches on and the “
Receiver Parameters
” standard display
appears.
왘
Keep the
STANDBY
button
pressed until “
OFF
” appears on the display panel.
The integrated antenna splitter and the booster supply voltage remain active so
that the antenna signals are still looped through to daisy-chained receivers.
that the antenna signals are still looped through to daisy-chained receivers.
• When in the operating menu, pressing the
STANDBY
button
entry (ESC function) and return you to the current standard display.
• The
STANDBY
button
is backlit in red both during operation and in standby
mode.
CAUTION!
Danger of hearing damage!
Listening at high volume levels for long periods can lead to permanent hearing defects.
왘
Set the headphone volume control
to the minimum position before putting the head-
phones on.