Sennheiser WiCOS User Manual
29
Switching the components on/off
Switching the components on/off
To switch the WiCOS conference system on, proceed as follows:
1. Switch the access point on (see next chapter).
2. Switch the conference units on (see page 31).
The connection is automatically established. The conference system
loads the last configuration used (see next chapters).
loads the last configuration used (see next chapters).
Switching the access point on/off
To switch the access point
on
:
왘
Set the on/off switch
m
to position “
1
”.
The last configuration used is loaded. The 3 status indicators
^
provide the following information:
You can use the factory default settings or adapt the configuration to your
needs (see page 44):
needs (see page 44):
m
`
Blue LED 1
Operating mode of the access point
flashes slowly
integrated operation (slave mode)
lights up
stand-alone operation
^
Red LED 2
Link quality (RF signal quality)
off
excellent
flashes slowly
good
flashes rapidly
fair
lights up
low
^
Blue LED 3
Connection status with the conference units
flashes rapidly
no connection
lights up
connection with at least 1 conference unit
Configuration
Function/Meaning
Detailed
information
information
Network settings
(IP address)
To load the web server and to
modify the configuration
modify the configuration
Country settings for radio
communication
communication
To set country-specific limit
values for radio frequencies and
transmission power
values for radio frequencies and
transmission power
Password protection
To protect the web server from
unauthorized access
unauthorized access
RF signal strength
To set the transmission power
Radio frequency
To set the radio frequencies to be
used in the 2.4 GHz and 5 GHz
frequency bands
used in the 2.4 GHz and 5 GHz
frequency bands