Sanyo R227 User Manual

US-10

1.    Press firmly on the battery cover and then rotate 

it  in  counter  clockwise  direction,  the  cover  will 
come off.

2.    Place  the  battery  (CR2032)  into  the  battery 

compartment according to the polarity markings, 
with the “+” sign facing up. 

3.     Place back the battery cover, press down slightly 

and rotate it in clockwise direction until it is firmly 
closed.

 
Note:  Remove the battery from the remote control if 
not in use for a long period of time. When the battery 
becomes  weak,  the  remote  control  will  not

  function 

properly. Replace with new battery.

Follow these precautions when using a battery in this device: 

Warning -Danger of explosion if battery is incorrectly replaced. Replace only with the same or 

equivalent type. 
Use only the size and type of battery specified. 
Be  sure  to  follow  the  correct  polarity  when  installing  the  battery  as  indicated  in  the  Battery         
Compartment. A reversed battery may cause damage to the device. 
If the device is not to be used for a long period of time, remove the battery to prevent damage 
or injury from possible battery leakage. 
Do  not  try  to  recharge  a  battery  not  intended  to  be  recharged;  it  can  overheat  and  rupture.         
(Follow battery manufacturer's directions.)
Battery shall not be exposed to excessive heat such as sunshine, fire or the like. 

1.    

2.
3.

4.

5.

6.

Configure Menu

1. Press the SELECT button.

(Note: if you make a mistake at any point, press the BACK button to go back to the previous 
screen.)

2. Turn the knob until 'Configure' is displayed 
3. Press the SELECT button.
4. Turn the knob until the display shows the option you want. 
5. Press  the  SELECT  button  to  choose  the  option  shown  on  the  display.  The  options  are 

explained below.

<Network Config>

Enables  you  to  scan  again  for  connection  to  another  wireless  network,  or  to  manually 
configure  the  network  parameters.  Use  this  if  you  take  the  Internet  radio  to  another  building 
where you want to use it.

<Version>

Displays the version numbers of the various parts of software on your Internet radio.