Russound ST2S User Manual

22

The ST2-RC remote control is the only means of
remote operation of the ST2S in a non--RNET system.
The ST2S front panel displays information for the
tuner that is receiving commands from the ST2-RC.
However, the ST2-RC commands do not change
which tuner is playing; that is done through the sys-
tem’s source selection. 

To switch the ST2 tuner in or out of standby mode,

push 

or any other button except TUNER 1 or 

TUNER 2.   

To control a tuner, push 

or 

. When

pressed, these buttons will be backlit green for Tuner
1 (SIRIUS) and amber for Tuner 2 (AM/FM). Each time
a tuner is selected, the next button press will refresh
the display with the current station or preset for that
tuner, 

and all subsequent button presses and memory

preset entries will be associated with that selected
tuner.

Push 

to switch between AM and FM reception.

Use 

and 

for manual tuning. To move quickly

through the stations or channels, press and hold
either of the Tune buttons for more than 1.5 seconds.

To directly select a station or channel, press 

,

and enter the two- or three-digit SIRIUS channel num-
ber,  or the three- or four-digit station frequency
(1071 for 107.1, etc.). European regions use five-
digit station frequencies.

Push 

to select an SIRIUS operating mode.

Push 

to exit the SIRIUS operating mode selection

menu.

The SEEK function is performed by pressing and

releasing 

to seek lower frequencies or 

for

higher frequencies. SEEK tuning begins at the current
frequency, seeks upward and stops at the next tuned

station. Pushing 

continues the SEEK function.

Once the highest frequency is reached, the tuner con-
tinues in SEEK mode at the lowest frequency. 

Press 

to toggle between stereo and mono mode.

STEREO or MONO appears briefly on the screen when
selecting mode. Normal operation is in stereo mode.
On a preset, the stereo/mono setting is saved for
that preset. 

Press 

to toggle between Distant and Local

mode. DISTANT or LOCAL appears briefly on the
screen when selecting mode. Normal operation is in
Distant mode. 

To recall a memory preset, select the desired tuner,

press 

and enter the desired bank number 

(1-6), then press 

and enter the desired preset

number (1 to 6). The memory presets can also be

accessed by using 

and 

to scroll through all

presets for the selected bank. 

The remote control stores two “favorites” (similar to
memory presets) per tuner. These are set simply by
selecting either Tuner 1 or Tuner 2, setting the

desired frequency and pressing and holding 

or

until “FAV1 (2) saved” appears on the tuner.

Stored Favorites are then recalled by pressing either

or .