Roksan Audio Mseries-1 User Manual

CLASSIFICATION: General Use 

 

Version:  3.27 

 

Page 3 of 8 

ENGLISH 

 
 

 
Your Caspian Power Amplifier is set to operate from a fixed supply voltage which is marked on a label next to the 
mains input plug. Before connecting the mains lead please check that your mains supply corresponds to this 
label as below: 
 
 

230V Products    ………………………………….Voltage Range:  220V – 240V 

 

115V Products    ………………………………….Voltage Range:  100V – 120V 

 

100V Products    ………………………………….Voltage Range:    90V – 110V 

 
The mains lead supplied with this product has an IEC mains socket which plugs into the IEC connector on the 
unit’s rear panel. The other end is normally attached to the appropriate mains plug for your country. In the UK 
this is the standard UK13A plug. 
 
This plug should ordinarily not be removed from the lead. If you do remove it, please dispose of it safely so that it 
cannot be plugged into a mains socket whilst in a potentially dangerous condition. We suggest that you obtain 
from your dealer a complete replacement lead. 
 
Should you move to another area where either the mains voltage or the mains plugs are different from those as 
supplied with your Power Amplifier, please contact the appointed ROKSAN distributor for assistance. 
 
Please observe correct mains polarity at all times. 
The Power Amplifier mains fuse is located on the rear panel next to the IEC mains connector. This must only be 
replaced by the fuse of the type and rating as described on the fuse rating label on the rear panel of the unit. 
 
 
If the equipment is likely to be unused for some time, unplug it from the mains supply. 
 

 
FCC WARNING 
This equipment may generate or use Radio Frequency energy. The user may lose the right to operate this 
equipment if unauthorised modifications are made. 
 
INTERFERENCE 
Properly installed, this unit should not cause harmful interference to radio communications, There is, however, no 
guarantee that such interference will not occur in a specific installation. If interference arises (which you can 
determine by switching the unit off and on) you could try to remedy this problem by the following: 
 

•  Re-orient or re-locate the receiving antenna 

•  Increase the distance between the Power Amplifier and receiver 

•  Connect the unit to a different mains circuit from that of the receiver 

•  Consult your ROKSAN appointed dealer or an experienced Radio/TV technician for help and advice 
 
LOCATION 
Your Caspian Power Amplifier should be located in a well ventilated area and kept away from sources of heat, 
dust, humidity and direct sunlight. 
 
The Power Amplifier may be positioned either as a free standing unit or alongside another audio/video product. 
Never place the Power Amplifier on carpet or any surface likely to hinder normal ventilation. 
Never allow liquids or other objects to fall into the unit. 
 
 
This unit contains no user serviceable parts. Do Not remove any panels or attempt to service it yourself. 
Unauthorised servicing will void the warranty.