Roadmaster 751428 User Manual
ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
#85-3905-01 07-10
1-800-669-9690
STOP LIGHT SWITCH BRACKET
INSTALLATION INSTRUCTIONS #751428
Failure to follow these instructions can result in
property damage, personal injury or even death.
property damage, personal injury or even death.
WARNING
ROADMASTER, Inc. 6110 NE 127th Ave. Vancouver, WA 98682 1-800-669-9690 fax 360-735-9300 www.roadmasterinc.com
1. Start by attaching the stop light switch to the
bracket — follow the separate instructions in-
cluded with this kit.
cluded with this kit.
2. Locate the existing stud under the steering col-
umn (Fig.A).
3. Place the stop light switch bracket over the
existing stud and bolt into place using the sup-
plied 8mm x 1.25 nut, 8mm flat washer and 8mm
lock washer (Fig.B).
plied 8mm x 1.25 nut, 8mm flat washer and 8mm
lock washer (Fig.B).
4. Now, adjust and wire the stop light switch —
follow the separate instructions included with this
k i t .
k i t .
When the installation is complete, verify that the
brake pedal retracts fully.
Unless they are installed correctly, the bracket and/
or other kit components may restrict or impede the
movement of the brake pedal — the brake pedal will not
retract fully.
movement of the brake pedal — the brake pedal will not
retract fully.
If the brake pedal does not retract fully, the brakes
will be applied continuously, which may cause severe
tire and/or brake system damage, as well as other con-
sequential, non-warranty damage.
tire and/or brake system damage, as well as other con-
sequential, non-warranty damage.
Failure to follow these instructions may cause prop-
erty damage, personal injury or even death.
WARNING
Fig.A
Fig.B
Stop Light Switch
Existing Stud
q
q
Parts List
(1) 8mm x 1.25 nut
(1) 8mm flat washer
(1) 8mm lock washer
(1) 8mm lock washer