Roberts Radio MP-16CD User Manual
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
Connecting AM loop aerial
For AM (medium wave) radio listening it is necessary to connect the AM
loop antenna which is supplied with your unit. Press down the two plastic
tabs on the AM loop anntenna socket on the back of the main unit. Care-
fully insert the two bare ends of the wire into the holes and then lift the
tabs back up to secure the wires.
loop antenna which is supplied with your unit. Press down the two plastic
tabs on the AM loop anntenna socket on the back of the main unit. Care-
fully insert the two bare ends of the wire into the holes and then lift the
tabs back up to secure the wires.
The placement of the antenna may need to be adjusted according to the
direction and strength of the signal from the desired AM radio station. Try
to place the antenna away from direct sources of interference (e.g. com-
puter monitors, light dimmers, etc). You may need to rotate the antenna
for optimum reception.
direction and strength of the signal from the desired AM radio station. Try
to place the antenna away from direct sources of interference (e.g. com-
puter monitors, light dimmers, etc). You may need to rotate the antenna
for optimum reception.
Remote handset battery replacement
1. Press in the tab on the left hand side of the battery tray and slide the
tray out.
2. Remove battery holder by pushing holder in direction shown.
3. Remove battery from holder.
4. Replace battery (CR2025 or equivalent) ensuring that the positive
side of the battery faces you with holder positioned as shown.
5. Replace the battery holder.
6