Renesas Stereo System SH7709S User Manual

Rev. 5.00, 09/03, page 509 of 760

15.4.2

Retransmission (Receive and Transmit Modes)

Retransmission when SCI is in Receive Mode: Figure 15.9 shows the retransmission operation
in the SCI receive mode.

1. When the received parity bit is checked and an error is found, the PER bit in SCSSR is

automatically set to 1. If the RIE bit in SCSCR is enabled at this time, an ERI interrupt is
requested. Be sure to clear the PER bit before the next parity bit is sampled.

2. The RDRF bit in SCSSR is not set in the frame that caused the error.

3. When the received parity bit is checked and no error is found, the PER bit in SCSSR is not set.

4. When the received parity bit is checked and no error is found, reception is considered to have

been completed normally and the RDRF bit in SCSSR is automatically set to 1. If the RIE bit
in SCSCR is enabled at this time, an RXI interrupt is requested.

5. When a normal frame is received, the pin maintains a three-state state when it transmits the

error signal.

Dp DE

(DE)

nth transfer frame

RDRF

PER

Retransmitted frame

Transfer frame n + 1

Figure 15.9 Retransmission in SCI Receive Mode