Psion Teklogix 8100107B User Manual

9.6.1  Charging Batteries

•

Slide the battery into a charge well, aligning the contacts on the battery with 
the contacts in the charge well.

9.6.2  Battery Charge Duration

A fully discharged battery can take up to 4 hours to charge. The quad battery charger 
stops applying power to the battery when it is fully charged

–

there is no risk of 

overcharge if the battery remains in the charge well. The 75% charge indicator is 
handy if you need a quick recharge

–

a quick charge often takes less than one hour.

9.6.3  Charge Indicators–The LEDs

Each battery charge well is equipped with an LED to indicate the charge status of 
the battery. When a battery is inserted in the charger, the colour and behaviour of the 
LED associated with the charge well in use indicates the status of the charge. Refer 
to Table 9.3 on page 313 for details.

9.6.4  Troubleshooting

9.6.4.1

Excessive Charge Duration

The charger is equipped with a recalibration function

–

a function that fully 

discharges and then fully recharges the battery. This process is necessary to 
recalibrate the battery capacity gauge internal to the battery. The charger attempts 
recalibration when: 

•

the battery capacity is at less than 30%, and 

•

the battery has undergone more than 40 partial charge cycles since the last 
full discharge.

The recalibration function extends the charge time by up to 2 hours.

9.6.4.2

Indicator Flashing Red

If the indicator flashes red:

•

Remove all batteries and disconnect the mains power cable. 

•

Wait at least 20 seconds, and then plug the cable in again.

If any of the charge well LEDs continue to flash red, the charger is defective and 
requires service. If all indicators are flashing red, there is a power supply problem 
and the charger requires service.