Psion Teklogix Schnellstart- Anleitung 7525 User Manual

The SE 923HP scanner (model # WA9002) is the internal scanner module available 
with the WORKABOUT PRO. To install it:

•

Remove the battery. If your unit is using AC power, disconnect it.

•

Remove the stylus and then, remove the end-cap at the top of the 
WORKABOUT PRO.

•

Slide the SW1401 switch to the left to shut off internal battery power.

•

Remove the back plate from the unit.

A scanner flex cable is already attached to the WORKABOUT PRO. You need to 
connect the flex cable to the internal scanner module.

•

Remove the adhesive tape that holds the flex cable in a folded position.

•

Insert the flex cable into the connector on the scanner module (refer to 
Figure 8.9 on page 268). If necessary, use pincers to hold the flex cable.

•

Fit the scanner module over the back of the WORKABOUT PRO—it 
replaces the back plate of the unit.

•

Fasten the module in place with the screws provided. Tighten the screws to 
a torque of 3 lbs-in (3kgf-cm), or until finger tight.

•

Slide the SW1401 power switch to the right to turn power back on, and 
replace the end-cap and battery. Tighten the end-cap screws to a torque of 3 
lbs-in (3kgf-cm), or until finger tight

8.1.7.1

Enabling The SE 923HP Scanner

•

Simultaneously, press and hold down the <BLUE> <ENTER> and left 
<SCAN> keys for a minimum of 6 seconds. A 

Command>

 prompt is dis-

played on the WORKABOUT PRO screen.

•

Type s to display the 

Scanner>

 prompt. A list of supported scanners is dis-

played.

•

Type 3 and press <ENTER> to activate scanner type SE 923HP.

•

At the 

Command>

 prompt, type 1 (one) to reboot the unit to Windows Mobile 

2003 SE.