Psion Teklogix Vehicle-Mount Computer 8525 G2 User Manual

2.10.2.2

EAP Credentials

Keep the following in mind when defining security settings:

•

If the credentials specified in the config are incorrect and that config is used, 
the authentication fails without an error message; you will not be prompted 
to enter correct credentials.

•

If the credentials are not specified in the config, when the radio tries to asso-
ciate using that config, you will be prompted to enter the credentials.

•

When prompted, you can enter valid credentials, enter invalid credentials, 
or cancel the operation.

•

If you enter valid credentials and tap OK, the radio will associate and 
authenticate.

•

If you enter invalid credentials and tap on OK, the radio will associate 
but will not authenticate; you will be prompted again to enter creden-
tials.

•

If you tap on Cancel or clear the credentials fields and tap on OK, the 
radio will not attempt to associate with that config until you perform 
one of the following actions (while the config is the active config):

•

Cause the vehicle-mount to go through a power cycle or sus-
pend/resume.

•

Disable and enable the radio, or tap the Reconnect button on the 
Diags windows.

•

Modify the config, and tap on Commit.

Alternatively, you can choose another config as the active config and then switch 
back to the config for which EAP authentication was cancelled.

2.10.2.3

ThirdPartyConfig

If you choose to configure ThirdPartyConfig, the SCU will work with the operating 
system’s Windows Zero Config (WZC) to configure radio and security settings for 
the CF radio installed in the unit.
Choosing this config means that WZC must be used to define the following radio 
and security options: SSID, Auth Type, EAP Type and Encryption.The SCU settings 
for ThirdPartyConfig include: Client Name, Power Save, Tx Power, Bit Rate and 
Radio Mode. These SCU settings along with SCU global settings and the WZC 
settings will be applied to the radio module.