Proxim 7920 User Manual
51
Below is a summary for changing this parameter on each model:
Model 7500: Uncheck the NON-RangeLAN2 Address Filter on
the Filter Configuration page of the 7500's Configuration Tool.
the Filter Configuration page of the 7500's Configuration Tool.
Model 7510/752x: No action is needed if the Access Point has
revision 1.4 or greater of the flash code image installed. If the
Access Point is using an earlier version of the flash code, set the
Filter Fixed Nodes parameter to “Not Filtering” in the Filter
Configuration Menu.
revision 1.4 or greater of the flash code image installed. If the
Access Point is using an earlier version of the flash code, set the
Filter Fixed Nodes parameter to “Not Filtering” in the Filter
Configuration Menu.
Model 753x, operating in TB or Single-Ring SR/TB mode:
There is no Filter Fixed Nodes parameter when operating the
Token Ring Access Point in these bridging modes. Instead, you
may configure the Access Point to forward packets destined for
up to 3 MAC address prefixes in addition to the RangeLAN2
prefix. These MAC address prefixes may be set in the Hardware
Filtering Configuration Menu.
There is no Filter Fixed Nodes parameter when operating the
Token Ring Access Point in these bridging modes. Instead, you
may configure the Access Point to forward packets destined for
up to 3 MAC address prefixes in addition to the RangeLAN2
prefix. These MAC address prefixes may be set in the Hardware
Filtering Configuration Menu.
Model 753x, operating in Multi-Ring SR/TB mode: Set the
Filter Fixed Nodes parameter to "Not Filtering" in the Filter
Configuration Menu.
Filter Fixed Nodes parameter to "Not Filtering" in the Filter
Configuration Menu.