Procom AL500HYLA User Manual

                        2                                                          AL058-01 

 

1. Check the heater completely and thoroughly for 

damage. DO NOT run a damaged heater. 

2. DO NOT alter the heater or operate a heater that 

has been modified from its original condition. 

3. Use only propane gas. 

4. Use only vapor withdrawal propane gas. If any 

question, contact your LP dealer. 

5. Do not use this heater as a wood-burning heater. 

Use only the logs provided with the heater. 

6. Inspect hose assembly before each use of the 

heater. If there is excessive abrasion or hose is cut, 

STOP USING HEATER! Replace with a new hose. 

7. This heater is for outdoor use only. Even so make 

sure that there is ample fresh air ventilation. Do not 

use in buildings, garages or other enclosed spaces. 

8. 

In the event that gas odor is detected, 

IMMEDIATELY STOP operation until gas supply 

has been located and corrected. 

9. Do not place the heater where directly exposed to 

water spray, rain, dripping water or wind. 

10.  Maintain minimum clearance to people or normal 

combustible material (like paper) of 2 feet. 

11.  Place heater on a stable, level surface. 

12. You must operate the heater with the heater 

screen in place. Make sure heater screen is in 

place before running heater. 

13.  This heater is designed to be smokeless. If logs 

ever appear to smoke, turn off heater and call a 

qualified service person. Note: during initial 

operation, slight smoking could occur due to log 

curing and heater burning manufacturing residues. 

14.  Do not attempt to move, handle or service while 

heater is hot or in operation. 

15.  Use only in accordance with local codes or, in the 

absence of local codes, with the National Fuel Gas 

Code ANSI223.1-1996. 

16. Do not hang or attach clothing or any other 

flammable materials on or near the heater. 

17.  Carefully supervise young children when they are 

in the vicinity of heater. 

18.  Heater becomes very hot while running. Keep 

children and adults away from hot surface to avoid 

burns or clothing ignition. 

19. Installation and repair should be done by a 

qualified service person. The appliance should be 

inspected before use and at least annually by a 

qualified service person. More frequent cleaning 

may be required as necessary. It is imperative that 

control compartment, burners and circulating air 

passageways of the appliance be kept clean.   

Install and use heater with care. Follow all local codes. 

In the absence of local codes, use the latest edition of 

The National Fuel Gas Code, ANSZ223.1, also known 

as NFPA54*. 

Available from : 

American National Standards Institute, INC. 

1430 Broadway, New York, NY10018 

National Fire Protection Association, INC. 

Batterymarch Park Quincy. MA 02269 

1. Remove top inner pack. 

2. Slide stove out of carton and set it on the flat floor. 

3. Remove protective packaging.(See FIG.2) 

4. Remove plastic wrap and carton from MID base. 

5. Turn the door knob clockwise, open heater door to 

take out log set, Remove all protective plastic wrap. 

6. Unwrap log set by cutting plastic ties. 

7. Check for any shipping damage. If stove or log is 

damaged, promptly inform dealer where you bought 

the stove.