Planet Audio ADE-3400v3 User Manual

3.6.4.2 Static Route

This page is used to configure the routing information. Here you can add / delete IP routes.

Click “Enable” to enable the Static Routing function, you can query the preset static routes,

delete an existing static route, or add a new static route. By default, the system has no

static route information.

Destination: The IP address where packets will go to.

Subnet Mask: The subnet mask of the destination IP address.

Next Hop: The gateway that the packets will pass by during transmission.

Metric: Metric represents the “cost” of transmission for routing purposes. IP Routing uses

hop count as the measurement of cost, with a minimum of 1 for directly connected networks.

Enter a number that approximates the cost for this link. The number need not to be precise,

but it must between 1 and 15. In practice, 2 or 3 is usually a good number.

Interface: The interface that the packets pass through on the device.

Click “Add Route” to add this routing information.