Phase Technology Motion Sensor FP Series User Manual

2. Remove motion sensor 
pod cover.

3. Remove motion sensor lens. 4. Place narrow lens into pod 

cover. Make sure lens is flush 
with outside of pod cover. 
Align the flat side of the lens w/ 
the flat side of the pod cover.

5. Place pod cover back on 
FP unit.

6. Complete.

 

Motion Sensor

1. Unpack FP speaker pod 
and FP Dome. 

Orange White /

Orange

Blue White (unused)

Green (unused)

Brown White /

Brown

     

White/Green 

Signal 

wire

for 5 Volt ttl signal

 
1. Attach the +12 V from the power supply to the  

 

    Orange white and orange wire pair. 

2. Attach the ground from the power supply to the brown      

    white and brown wire pair. 

3. Attach the ground from the voltage sensor controller to 
    the brown and white wire pair also. 

4. Attach the signal wire to the white/green single wire. 
 
5 Volt ttl signal (White/Green Signal wire)
       • 0 Volts = motion detected
       • 5 Volts = no motion detected
       • The green and blue/white  
          wires are unused.

1k to 12 Volt pullup (Blue Signal wire)
       • 12 Volts = motion detected
       • 0 Volts = no motion detected
       • The green and blue/white  
          wires are unused.

Blue Signal wire for 

1k to 12 Volt pullup

Signal wire

Ground

Ground

Positive

(not included)

(not included)