Pertech A470 User Manual
A470 Users Guide
Pertech® 2006
iv
Important Information to the User
In order to ensure compliance with the Product Safety, FCC, and CE marking requirements, you must use the power supply,
power cord, and interface cable, which were shipped with this product or which meet the following parameters:
power cord, and interface cable, which were shipped with this product or which meet the following parameters:
Power Supply
Input power to this product must be provided by one of the following:
(1) A NRTL Certified power source with a Limited Power Source.
(LPS) output for use in North America, input rated 100-240 Vac, 1.5 A, 50/60 Hz, output rated 24 Vdc at 2.5 A. Maximum and
60W Maximum, or
(2) A Power source with a Limited Power Source (LPS) output Certified by an agency recognized in the country of installation,
input rated 100-240 Vac, 1.5 A, 50/60 Hz, output rated 24 Vdc at 2.5 A. Maximum and 60W Maximum.
Use of this product with a power supply other than the Pertech power supply will require you to test this power supply and
Pertech printer for FCC and CE mark certification.
(1) A NRTL Certified power source with a Limited Power Source.
(LPS) output for use in North America, input rated 100-240 Vac, 1.5 A, 50/60 Hz, output rated 24 Vdc at 2.5 A. Maximum and
60W Maximum, or
(2) A Power source with a Limited Power Source (LPS) output Certified by an agency recognized in the country of installation,
input rated 100-240 Vac, 1.5 A, 50/60 Hz, output rated 24 Vdc at 2.5 A. Maximum and 60W Maximum.
Use of this product with a power supply other than the Pertech power supply will require you to test this power supply and
Pertech printer for FCC and CE mark certification.
Interface Cable
A shielded (360 degree) interface cable must be used with this product. The shield must be connected to the frame or earth
ground connection or earth ground reference at EACH end of the cable.
Use of a cable other than described here will require that you test this cable with the Pertech printer and your system for FCC
and CE mark certification.
ground connection or earth ground reference at EACH end of the cable.
Use of a cable other than described here will require that you test this cable with the Pertech printer and your system for FCC
and CE mark certification.
Power Cord
For North America a NRTL recognized detachable power cord must be used. For applications where the power supply module
may be located on the floor, a power cord with Type SJT marking must be used.
For applications outside North America, power cords which meet the country of installation’s certification and application
requirements must be used.
Use of a power cord other than described here may result in a violation of safety certifications which are in force in the country of
use.
may be located on the floor, a power cord with Type SJT marking must be used.
For applications outside North America, power cords which meet the country of installation’s certification and application
requirements must be used.
Use of a power cord other than described here may result in a violation of safety certifications which are in force in the country of
use.