Pelco Network Cables C2485M-D User Manual

10

C2485M-D  (7/05)

To interface with a Spectra III dome drive or IPS-RDPE-2 remote data port using a Palm handheld, first 
install the control/upload utility and then install the IPS-CABLE. 

The Control/Upload Utility is compatible with Palm OS version 3.5 or higher. 

NOTE: Know how to operate a Palm OS-compatible handheld before attempting to control or 
upload software using the IPS-CABLE. 

1. Insert the Resource CD into the CD drive. The main menu appears on the monitor. 

NOTE: If autoplay is not enabled on your system, you need to navigate to the CD drive and select 
Start to open the main menu. 

2. Click the Control/Upload Utility button for Spectra III, Esprit, or ExSite. The File Download box 

appears on the monitor. Open or save the Control/Upload Utiltiy file to the PC. 

3. Use the HotSync

®

 function to install the application software onto the Palm OS-compatible 

handheld. Refer to the manual supplied with the Palm OS-compatible handheld for 
instructions on how to perform a HotSync operation.

To install the IPS-cable, refer to Figure 2 and do the following: 

1. Connect a Palm OS-compatible serial cable (not supplied) to the handheld serial port. 

2. Connect the 9-pin male connector from the IPS-CABLE to the Palm OS compatible serial cable. 

3. Connect the IPS-CABLE to the RJ-45 port of the Spectra III dome drive or IPS-RDPE-2.

 NOTE: When connected, the IPS-CABLE will interrupt control from the normal control source.