Pelco PelcoNet Multimedia Transmission Via Network Net350 User Manual

C2907M-D (4/05)

43

You can use this configuration page to set the parameters of the COM2 RS-232 serial interface port.

Figure 33.  Configuration Page for COM 2 Interface Settings 

Serial port function 

Terminal 

Use the pull-down menu to select the function for serial port 2 from the pull-down menu: Terminal, Transparent, or 
Pelco Prot (protocol). 

If the unit will be operated from a terminal, select Terminal. If the port must transmit data transparently, select 
Transparent. You can use Pelco Prot to send any kind of control data for a Spectra, Esprit, Genex, or a Pelco 
matrix. 

Baud rate 

19200 

Use the pull-down menu to select a transmission rate from 600 to 115200 baud. Refer to Appendix A for settings.

Data bits 

8 

The number of data bits is set at 8 per character.

Stop bits 

1 

Use the pull-down menu to select the number of stop bits (1 or 2) per character. Refer to Appendix A for settings. 

Parity check 

None