Pelco pelco ccc4000pckit User Manual
Pelco Manual C1931M (5/99)
7
HUE
Hue ensures that a monitor accurately displays colors by correcting the phase of the color
signal. Hue applies only to NTSC cameras.
signal. Hue applies only to NTSC cameras.
CHANGING THE CAMERA’S CONTROLS
To change the camera’s controls:
1.
In the Program section, select
Program 1
,
Program 2
, or
Program 3
depending
on where you want to save the new settings.
2.
If the correct communications port is not selected, select the port where you installed
the DB-9 cable.
the DB-9 cable.
3.
Select one of the following
White Balance
controls:
•
In normal situations, select
Full Auto
for all color temperature changes between
2500 and 6500 Kelvin. When the scene contains 5 percent or less white, Full
Auto does not perform at an optimum level.
Auto does not perform at an optimum level.
•
For incandescent indoor lighting, select
Fixed Indoor
(fixed-color temperature
of 3200 Kelvin).
•
For clear-daylight, outdoor lighting, select
Fixed Outdoor
(fixed-color tempera-
ture of 5600 Kelvin).
•
For fluorescent lighting, select
Fixed FL/TL
(fixed-color temperature of 4500
Kelvin).
•
For special light conditions, select
Full Remote
(corrects every color tempera-
ture between 2500 and 6500 Kelvin).
4.
Do one of the following:
If you selected Full Auto, adjust the speed.
or
If you selected Full Remote, adjust the percent of red or blue in the scene as neces-
sary using the appropriate scroll bar.
sary using the appropriate scroll bar.
5.
Set the V-phase using the scroll bar. If only one camera is connected to a monitor and
VCR, turn off the Line-Lock control. Turning off this control improves the picture quality.
VCR, turn off the Line-Lock control. Turning off this control improves the picture quality.
6.
Set the Edge Enhancement by selecting the
On/Off
control. If a check mark appears,
the edge enhancement control is turned on.
7.
Using the appropriate scroll bar, do one of the following:
If you are setting up an NTSC camera, set the Illumination Control by adjusting the
Shutter and AGC as necessary.
Shutter and AGC as necessary.
or
If you are setting up a PAL camera, set the Illumination Control by adjusting the Iris
and AGC as necessary.
and AGC as necessary.
8.
If you are setting up an NTSC camera, set the Hue using the scroll bar.