Pelco Electronic Keyboard C586M User Manual
22
Pelco Manual C586M (9/99)
PROGRAMMING
This section applies only to programming the multiplexer. To program the
multiplexer server, refer to the server manual.
multiplexer server, refer to the server manual.
Programming allows you to configure the multiplexer from the KBD4000V for the way that
you want your system to operate. The multiplexer automatically selects the most common
operating parameters. However, some minimal programming may be required to make your
system work.
you want your system to operate. The multiplexer automatically selects the most common
operating parameters. However, some minimal programming may be required to make your
system work.
Programming of system, camera, and VCR setup; camera sequencing; and alarm and
activity detection are done through on-screen menus that are displayed on the main
monitor. A password can be enabled to prevent unauthorized access to the menus.
activity detection are done through on-screen menus that are displayed on the main
monitor. A password can be enabled to prevent unauthorized access to the menus.
Programming of the picture-in-picture, and 4-, 9-, and 16-camera displays can be done
directly without going through menus.
directly without going through menus.
IMPORTANT NOTE
Before the keyboard can be used to control the multiplexer(s), perform the following steps at
the multiplexer(s) front panel.
the multiplexer(s) front panel.
1.
Press the VIEW button for approximately three seconds. The basic SYSTEM Setup
menu appears.
menu appears.
2.
The currently selected menu item blinks. Use the arrow buttons to highlight
ADVANCED SETUP.
ADVANCED SETUP.
3.
Press the +/- button. The Advanced System Setup menu appears Skip steps 4 and 5 if
your system has only one multiplexer.
your system has only one multiplexer.
4.
Use the arrow buttons to move the cursor to UNIT ID.
5.
Press the +/- button to select the UNIT ID of the multiplexer.
6.
Use the arrow button to move the cursor to COMM.TYPE.
7.
In the polled communication mode (switch 4 OFF), one multiplexer must be the master
and others slaves. In the non-polled mode (switch 4 ON), all multiplexers must be slaves.
and others slaves. In the non-polled mode (switch 4 ON), all multiplexers must be slaves.
8.
Use the arrow button to go to EXIT. Press the +/- button to exit the menu. The
keyboard can now be used to program the multiplexer.
keyboard can now be used to program the multiplexer.
PASSWORD
You can program the multiplexer to request a password for access to programming menus.
The password is enabled in the Advanced System Setup menu (refer to the
The password is enabled in the Advanced System Setup menu (refer to the
Advanced
System Setup
section).
The universal password is 3916 and cannot be changed. This password must be entered
whenever one is requested. The password is entered from the keyboard by pressing each
number followed by pressing the CAM key: 3, CAM, 9, CAM, 1, CAM, 6, CAM.
whenever one is requested. The password is entered from the keyboard by pressing each
number followed by pressing the CAM key: 3, CAM, 9, CAM, 1, CAM, 6, CAM.
NOTE:
Whenever a
multiplexer server is
installed, programming the
multiplexer
installed, programming the
multiplexer
must be done
at the multiplexer front
panel. In this situation, the
multiplexer cannot be
programmed from the
keyboard. The keyboard can
panel. In this situation, the
multiplexer cannot be
programmed from the
keyboard. The keyboard can
only
be used to program
the multiplexer server,
not
the multiplexer.