Pelco CCC1390H Series Camera C2924M (4/05) User Manual
16
C2924M (4/05)
CONNECTING EXTERNAL CONTROL
The external control connector on the rear panel lets you remotely access and control the CCC1390H Series camera. The external control
connector assembly is a seven-pin micro (1.25 mm) connector with wires (26 AWG) and connector cover.
connector assembly is a seven-pin micro (1.25 mm) connector with wires (26 AWG) and connector cover.
You can access and configure the menu settings from any Pelco keyboard, receiver, or other device that supports the Pelco D or Pelco P protocol.
The camera supports the following settings:
The camera supports the following settings:
•
Baud rate:
2400, 4800, 9600, 19200
•
Start bit:
1
•
Data bits:
8
•
Stop bit:
1
•
Parity:
None
You can also control day/night filter operation from an external switch.
Figure 6 identifies the pin connections for the enclosed external control connector assembly. It also identifies pins 1 and 7.
Figure 6. Installing the External Control Connector
TO CONTROL
DEVICE
GND
RX+
RX-
REMOVE
CONNECTOR
COVER
CONNECTOR
COVER
INSTALL
CONNECTOR
COVER
PIN 7
PIN 1
Pin
Lead Color
1
Pelco Data RX+
Red
2
Pelco Data RX–
White
3
Ground
Black
4
Pelco Data TX+
Red
5
Pelco Data TX–
White
6
Ground
Black
7
Day/Night Control Signal Input
Brown