Pelco CCC1390H Series Camera C2924M (4/05) User Manual

 

8

C2924M (4/05)

 

CCC1390H Series Camera

 

CCC1390H-6

1/3-inch high resolution day/night, WDR, CCD camera, 24 VAC or 12 VDC, NTSC format

CCC1390H-6X

1/3-inch high resolution day/night, WDR, CCD camera, 24 VAC or 12 VDC, PAL format

 











3

3a

Lens Mount: Mount a standard CS-mount lens to the CCC1390H Series camera (refer to Lens Mounting). To use a C-mount lens, install a 
C/CS-mount adapter.



Back Focus Locking Screw: Use a 1.5-mm Allen wrench to adjust the back focus (refer to Lens Focusing).



3a

 Mount Adapter: Use the top or bottom mount hole. The maximum thread depth (top) is 0.188 inches (4.7 mm); the 

adapter extends the thread depth (top) to 0.25 inches (6.4 mm). The maximum thread depth (bottom) is 0.25 inches (6.4 mm). Refer to Camera 
Mounting.



Serial Terminating Switch: Use this switch to terminate the serial signal at the last camera on the serial chain (refer to Connecting 
External Control).



Auto Iris Lens Connector: Insert the four-pin connector from the DC-drive auto iris lens into this connector (refer to Lens Mounting).



Video Output Connector: Connect a coaxial video cable to this BNC connector to output the video image (refer to Connecting Video).

Setup Button: Use this five-position button to configure the camera either directly (refer to Quick Setup) or through the setup menus (refer 
to Accessing Setup Menus).



Power Terminal Strip: Use this three-pin, push-in type terminal strip to connect either 12 VDC or 24 VAC power (refer to Connecting 
Power).

Indicators: Use these indicators to quickly determine camera status (refer to Quick Setup).



External Control Connector: Use this seven-pin connector to connect the camera to one or more serial devices. Use it also to connect an 
external day/night filter switch. Refer to Connecting External Control for more information.