Troy-Bilt 24A-070F766 User Manual
12
SECTION 6: SERVICING YOUR YARD VACUUM
Drive Control Cable Adjustment
Adjust the drive control cable if the yard vacuum does
not self propel with the drive control engaged, or if the
unit hesitates while the engine maintains the same
speed after approximately 20 hours of use.
not self propel with the drive control engaged, or if the
unit hesitates while the engine maintains the same
speed after approximately 20 hours of use.
To move the z-fitting of the drive control cable from its
factory set position in the front hole of the drive control
to the rear hole, proceed as follows:
factory set position in the front hole of the drive control
to the rear hole, proceed as follows:
•
Remove the drive control by pushing the right side
of the control out of the right hole in the upper
handle. Pivot control down towards the lower
handle and then straight up to remove it from the
left hole in the upper handle. See Figure 13A.
of the control out of the right hole in the upper
handle. Pivot control down towards the lower
handle and then straight up to remove it from the
left hole in the upper handle. See Figure 13A.
Figure 13
•
There is now sufficient slack in the drive control
cable to grasp the z-fitting with your hand and move
it from the front hole to the rear hole of the drive
control. See Figure 13B.
cable to grasp the z-fitting with your hand and move
it from the front hole to the rear hole of the drive
control. See Figure 13B.
IMPORTANT:
Make sure to insert the z-fitting into the