Tripp Lite SNMP Solo MT-SE-37/02 User Manual
Tripp Lite
Configuration
21
This messages informs or directs you:
1. The Setup program has ended.
2. Turn off the DIP switch (switch 1 UP).
3. Disconnect the power supply from the SNMP Solo.
4. Re-connect the power supply to the SNMP Solo.
TelNet Options
You can also TelNet to the IP address of the SNMP Solo after it
has been installed on your network. Once you have
successfully established a TelNet connection with the adapter
you may access the configuration menu as if you were directly
attached to it via the configuration port.
has been installed on your network. Once you have
successfully established a TelNet connection with the adapter
you may access the configuration menu as if you were directly
attached to it via the configuration port.
Figure 13 Telnet options
The TelNet options menu gives some additional features that
you can use after you have established a TelNet connection.
you can use after you have established a TelNet connection.