Triax TSR 1000 User Manual

 

34

 

♦  Press [Volume Up/Down / Channel Up/Down] to position the 

round mark. 

♦  Press [OK] to set your stone. 

♦  Press [MENU] to quit the game and return to the game menu. 

 
6.4  Factory Default 
When you press [OK] on the “Factory 
Default” item: 
1.  A dialogue box will occur where you 

need to enter the password. 

2.  After you input the correct password a 

warning message will be displayed 
like the one beside. 

3.  If you select “Yes” then all changes 

you made will be reset to default 
values. Make sure you really want to 
do this! 

4.  Press [MENU] in both steps will close the window without resetting the 

receiver. 

 
6.5  Software Upgrade 
1.  This function allows you to upgrade 

the software of the receiver. This can 
be done from PC to receiver or from a 
master receiver to a slave receiver. 

2.  Connect master receiver or PC to the 

slave receiver via serial 
interface(0-Modem cable). Enter the 
“Software Upgrade” menu of the 
master receiver and press [Volume 
Up/Down] to change the upgrade 
mode. Upgrade modes include: allcode / maincode / CAS-data /ScriptGUI / 
Radioback / default db / userdb. 

3.  Switch on the slave receiver. 
4.  Mark “Start” on the master reeciver and press [OK] to start upgrade. 

Wait until the display on the front panel shows “END”. Then switch off the 
receiver and on again. Now the new software is used. 

5.  Press [MENU] to save the setting without upgrade.