Triax SR-26 User Manual
- 4 -
SATELLITE ANTENNA
To have an excellent function of the sat-receiver, it is necessary to install the antenna
correctly. Please avoid under all conditions to have a short circuit at the antenna cable
conductor (LNB receiver). The sat-receiver is equipped with a LNB short-circuit pro-
tection.
PUTTING ON THE BATTERIES OF THE
REMOTE CONTROL
First open the battery cover on the underside of the remote control. Put on both bat-
teries 1.5Volt (R03/AAA) referring to the imprinted symbols (+/-) in the battery case and
put on the battery cover again.
While using the remote control, direct it towards the front side of the receiver. If the
remote control do not work or the chosen function could not be made, the batteries
are most probably exhausted and they should be replaced as soon as possible.
Please use only the leak proof batteries. It is the best to take out the batteries from
remote unit in case you wouldnt use the remote control unit for long time.
CONNECTION OF YOUR TV WITH THE SATELLITE
RECEVIER
Connection to the TV:
1. Connect your terrestrial antenna to the ANT IN signed socket of the satellite re-
ceiver.
2. Connect an antenna cable between the TV OUT signed socket of the satellite
receiver and the antenna socket of the TV, as it is used for video recorders.
3. Carefully plug in the connector of the satellite antenna cable to the LNB INPUT
(920-2150MHz) signed socket of the satellite receiver.
Putting into operation:
Be sure that you put through all the cable connection. After plugging in the mains
supply of the set to the mains supply, a red light will be seen on the front panel. Then,
user can turn on the receiver by pressing standby button on remote control or keypad.
The red light in front panel will disappear.