Transition Networks BFFG1XXX-1XX User Manual
Appendix B: FBRM/BFFG Technical Specifications
Transition Networks
Specifications, notices, and warnings, continued
Notices
• The information in this user’s guide is subject to change. For the most up-to-date
information on the FBRM/BFFG Devices, see the user’s guide on-line at:
www.transition.com.
www.transition.com.
• Product is certified by the manufacturer to comply with DHHS Rule 21/CFR,
Subchapter J applicable at the date of manufacture.
• IMPORTANT Copper based media ports: e.g., Twisted Pair (TP) Ethernet, USB,
RS232, RS422, RS485, DS1, DS3, Video Coax, etc., are intended to be connected
to intra-building (inside plant) link segments that are not subject to lightening
transients or power faults.
to intra-building (inside plant) link segments that are not subject to lightening
transients or power faults.
CAUTION: Copper-based media ports, e.g., Twisted Pair (TP) Ethernet, USB,
RS232, RS422, RS485, DS1, DS3, Video Coax, etc., are NOT to be connected to
inter-building (outside plant) link segments that are subject to lightening transients or
power faults. Failure to observe this caution could result in damage to equipment.
RS232, RS422, RS485, DS1, DS3, Video Coax, etc., are NOT to be connected to
inter-building (outside plant) link segments that are subject to lightening transients or
power faults. Failure to observe this caution could result in damage to equipment.
Warnings
WARNING: Visible and invisible laser radiation when open: DO NOT stare into the
beam or view the beam directly with optical instruments. Failure to observe this
warning could result in an eye injury or blindness.
beam or view the beam directly with optical instruments. Failure to observe this
warning could result in an eye injury or blindness.
WARNING: Use of controls, adjustments or the performance of procedures other
than those specified herein may result in hazardous radiation exposure.
than those specified herein may result in hazardous radiation exposure.
WARNING: If the media Device is an IEEE802.3-2005 Powered Device (PD)
capable of receiving power via the Medium Dependent Interface (MDI) leads, the
power source, connector, and cabling attached to the barrel power connector must
meet the isolation requirement specified in IEEE802.3-2005. Failure to observe this
warning could result in an electrical shock.
capable of receiving power via the Medium Dependent Interface (MDI) leads, the
power source, connector, and cabling attached to the barrel power connector must
meet the isolation requirement specified in IEEE802.3-2005. Failure to observe this
warning could result in an electrical shock.
IMPORTANT
The xFBRM/xBFFG Device product family is not compatible with the CPSMM-200
and CPSMM-210 management modules when they are used in a cascaded
application. The xFBRM/xBFFG can be installed in the “master” chassis with the
CPSMM-200, but they can not be installed in a cascaded chassis using the CPSMM-
210.
and CPSMM-210 management modules when they are used in a cascaded
application. The xFBRM/xBFFG can be installed in the “master” chassis with the
CPSMM-200, but they can not be installed in a cascaded chassis using the CPSMM-
210.
Alternatively, the xFBRM/xBFFG can be used with the CPSMM-120 base
management module, which does not support cascading of the chassis.
management module, which does not support cascading of the chassis.
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
121