TP-LINK TL-WN951N User Manual

 

This equipment has been tested and found to comply with the limits for a Class B digital device, 

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates, 

uses and can radiate radio frequency energy and, if not installed and used in accordance with 

the instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does 

cause harmful interference to radio or television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try to correct the interference by one or 

more of the following measures: 

• 

Reorient or relocate the receiving antenna. 

• 

Increase the separation between the equipment and receiver. 

•  Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.   

• 

Consult the dealer or an experienced radio/ TV technician for help. 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 

conditions: 

1)  This device may not cause harmful interference. 

2)  This device must accept any interference received, including interference that may cause 

undesired operation. 

Any changes or modifications not expressly approved by the party responsible for compliance 
could void the user’s authority to operate the equipment. 
 
Note: The manufacturer is not responsible for any radio or TV interference caused by 
unauthorized modifications to this equipment. Such modifications could void the user’s authority 
to operate the equipment. 

This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled 
environment. This device and its antenna must not be co-located or operating in conjunction 
with any other antenna or transmitter. 

“To comply with FCC RF exposure compliance requirements, this grant is applicable to only 

Mobile Configurations. The antennas used for this transmitter must be installed to provide a 

separation distance of at least 20 cm from all persons and must not be co-located or operating 

in conjunction with any other antenna or transmitter.”