Panasonic Attune II Operating Guide
20
Setup procedures
Setup of this product should only be performed by
qualified service personnel or system installers.
qualified service personnel or system installers.
wSwitch compartment
Unscrew the screw and open the switch
compartment when the power of the Belt Pack
is off.
compartment when the power of the Belt Pack
is off.
Cover
Refer to the “DIP switch setup” on the right,
and set the DIP switches.
and set the DIP switches.
After finishing the setup, replace the cover.
wDIP switch setup
Remove the switch cover and you will see a 4-bit DIP switch
and a 1-bit DIP switch.
and a 1-bit DIP switch.
Initial Setting
1
3 4
5
p Be sure to turn off the Belt Pack. Otherwise, the DIP
Switch will not be activated until you turn the power off
and on again.
and on again.
Note
No.
Function
ON
OFF
1
Auto-Talk-Lock ON/
OFF
OFF
ON
OFF
2
Talk button setting
Talk-Lock
PTT
3
Page button setting
Page-Lock
PTP
4
Center Module
model selection
model selection
WX-C3010
WX-CC411
WX-CC412
WX-CC412
5
Unused
–
Normal
operation
operation
No.1
Auto-Talk-Lock ON/OFF
ON:
ON:
Auto-Talk-Lock ON
OFF: Auto-Talk-Lock OFF
No.2
Talk button setting
ON:
ON:
Talk-Lock
OFF: PTT
No.3
Page button setting
ON:
ON:
Page-Lock
OFF: PTP
No.4
Center Module model selection
ON:
ON:
WX-C3010
OFF: WX-CC411, WX-CC412
No.5
Unused
Always set to OFF.
Always set to OFF.