Toro EC-XTRA Landscape Timer, 6-Zone (53794) Installation Guide

Installing the Cabinet

1. For safe, reliable operation, select an installation site

which will provide the following conditions:

• Protection from irrigation spray, exposure to direct

sun during the hottest hours, wind and snow.

• Access to a grounded power source which is not

controlled by a light switch or utilized by a high

current load appliance, such as a refrigerator or air

conditioner.

• Access to the sprinkler control valve wiring and

optional accessory wiring.

2. Drive a wood screw (provided) into the wall at eye

level (A). Leave the screw extended approximately

1/4″ from the wall.

Note

: If you are installing the timer on drywall or

masonry, install screw anchors to prevent screws

from loosening. Use the dimension shown to predrill

holes for screw anchors.

3. Hang the cabinet on the screw using the keyhole

slot (B) on the back panel. Make sure the cabinet

slides down securely on the screw.

4. Install the lower mounting screw(s) and tighten

securely.

Note: Conduit and adapters are not provided. Install

conduit as required by local electrical codes.

5. Install 1/2″ conduit (C) for power/equipment ground

wires and 3/4″ conduit (D) for valve wires.

Note: After installation, store the Quick Start Guide

on the hook located on the inside of the door.

MANUAL

START

NEXT

OFF

″

(15.24mm)