Toshiba MJ-1103 User Manual

MJ-1103/1104

DISASSEMBLY AND INSTALLATION

4 - 124

4.12 Procedure for lowering the movable tray

The movable tray can be lowered by releasing its driving gear without disassembling the finisher.

(1) Open the stationary tray.

Fig. 4-349

(2) While the movable tray is held with your

hand, insert the screwdriver in the hole-A on
the rear cover.

Notes:

• Be sure to hold the movable tray with

your hands because it may fall when the
screwdriver is pushed.

• Use a screwdriver with a diameter of 8

mm or less.

Remark:

Since the insertion of the screwdriver has
released the driving gear of the movable tray,
it can now be lowered. If the screwdriver is
taken out, the movable tray will stop in that
particular position.

Fig. 4-350

(3) The movable tray can be moved upward

without being released by the screwdriver.

Note:

Be sure that the movable tray does not stay
above its paper-full sensor. If printing is per-
formed with the sensor turned ON, "Movable
tray paper-full detection error" (CB31) will
occur. The movable tray must be moved
lower than the sensor.

Fig. 4-351

Stationary tray

Jam access lever

Movable tray

Sensor

Movable tray