Technics SC-DV170 User Manual

Page of 56
5
Before use
RQT5471
A
C
D
E
30–35 mm
100 mm
7–9 mm
Ø7.5~9.5
B
127V     110V     220–230V     240V
120
e
 
30
e
 30
e
 
DVD/Video CD/
CD changer
(SL-DV170)
Sound
processor
(SH-DV170)
e
 Cassette deck
(RS-DV170)
Tuner/amplifier
(SA-DV170)
Sound processor
(SH-DV170)
Tuner/amplifier
(SA-DV170)
DVD/Video CD/CD changer
(SL-DV170)
Cassette deck
(RS-DV170)
Center speaker
(SB-PC75)
Front speaker (R)
(SB-EH760)
Installation
»
A
Set the voltage
(Except for the United Kingdom, Continental Europe, Russia,
Australia and N.Z.)
Be sure to disconnect the AC mains lead before setting the voltage.
Use a flat-head screwdriver to turn the voltage selector to the appro-
priate position for the area in which this system is to be used.
If the power supply in your area is 115 V, 120 V or 230 V, set the
voltage selector as follows:
³
For 115 V: set to 110 V
³
For 120 V: set to 127 V
³
For 230 V: set to 220–230 V
Note that the unit will be seriously damaged if this setting is not made
correctly.
Locating the components
[B]
 Side-by-side set-up/
[C]
 Stacking
Note
Left and right front speakers are exactly the same.
Use only the supplied speakers.
The combination of the system and the speakers provides the best
sound. Using other speakers can damage the unit and sound quality
will be negatively affected.
»
D
Placement of center/surround
speakers (and subwoofer)
Center speaker
Place the center speaker (
h
) directly above the television.
Surround speakers
Place the surround speakers (
i
j
) on either side of the listening
position, or slightly to the rear, about 1 meter higher than ear level.
Place the speakers with the Technics logo facing toward the listening
position.
However the position should be adjusted to your personal prefer-
ence, because the effect varies to some degree depending upon the
type of music and the music source.
Note
If you are unable to position the surround speakers as recommend-
ed, you can put them near the front speakers and still achieve a sur-
round-like effect (
á
 page 35, “VIRTUAL REAR SURROUND”).
[E]
Attaching to a wall
Set speaker onto screws and slide through the bracket to lock into
position.
Note
The wall or pillar on which the speaker systems are to be attached
should be capable of supporting 5 k
g
.
Subwoofer
(Included only for areas other than the United Kingdom, Conti-
nental Europe, Australia and N.Z.)
The subwoofer (
m
) can be placed anywhere as long as it is standing
and not too far from the television.
If irregular coloring occurs on your television
Turn the television off for about 30 minutes.
The television’s demagnetizing function should correct the problem.
If it persists, move the speakers farther away from the television.
Front speaker (L)
(SB-EH760)
Front speaker (L)
(SB-EH760)
Front speaker (R)
(SB-EH760)
Surround
speaker (L)
(SB-PS75)
Surround
speaker (R)
(SB-PS75)
k
 Listening
position
Front view
Front view
The front, center, and surround speakers should be placed
at approximately the same distance from the listening posi-
tion. The angles in the diagram are approximate.
a
 (Bottom of tuner/amplifier)
Subwoofer
(SB-W85)
Caution
³
Use the speakers only with the recommended system.
Failure to do so may lead to damage to the amplifier
and/or the speakers, and may result in the risk of fire.
Consult a qualified service person if damage has oc-
curred or if you experience a sudden change in perfor-
mance.
³
Do not attempt to attach these speakers to walls using
methods other than those described in this manual.
VOLTAGE ADJUST SWITCH