Tascam IF-DM User Manual
26
IF-FW/DM
MK
II & DM-Mixer Routing
The IF-FW/DM
MK
II appears to the Mixer just like any other
optional I/O card except that it has 32 channels of I/O instead of 8.
(Note): Even if the card is currently set to 16 inputs or 16
outputs, the routing matrix will still present the full 32
channels for configuration.
(Note): Even if the card is currently set to 16 inputs or 16
outputs, the routing matrix will still present the full 32
channels for configuration.
Mixer Outputs
DM-3200
By default, the DM-3200 routes busses 1 – 16 to IF-FW/DM
MK
II
outputs 1-16 and duplicates these to outputs 17-32.
These routing settings can be changed in the OUTPUT SLOT tab
of the DM-3200’s ROUTING screen.
These routing settings can be changed in the OUTPUT SLOT tab
of the DM-3200’s ROUTING screen.
Routing Control
Turn the third pod under
the LCD screen (POD3)
to move the cursor
between the IF-FW/DM
Turn the third pod under
the LCD screen (POD3)
to move the cursor
between the IF-FW/DM
MK
II’s 32 channel
outputs, which are
displayed in banks of 8 on
the far left of this screen.
Turn the JOG/DATA dial
to change the routing and
press ENTER to confirm.
displayed in banks of 8 on
the far left of this screen.
Turn the JOG/DATA dial
to change the routing and
press ENTER to confirm.
Use POD4 to narrow down the choices and save time when
selecting a source for each output.
If the BUSS #/DIR # output is selected, then the direct output from
a DM-4800 channel input can be easily selected by turning on
Direct Out on the channel input – use the “DIRECT” key in the
front panel “OUTPUT ASSIGN” section.
selecting a source for each output.
If the BUSS #/DIR # output is selected, then the direct output from
a DM-4800 channel input can be easily selected by turning on
Direct Out on the channel input – use the “DIRECT” key in the
front panel “OUTPUT ASSIGN” section.