Tascam IF-DM User Manual

2. Right click on My Computer, select “Properties” and left

click this.

3.  Select the Hardware Tab
4.  Click the Device Manager
5.  In the list under “Sound, video and game controllers”, there

should be an entry for “TASCAM IF-FW/DM mkII”.

6. If this entry is not there, or if there is a yellow “!” mark

against it, uninstall and re-install the drivers. Do not
attempt to use the “Update drivers” option from here.

7. If there is a Red “X” mark against the entry, the device has

been disabled. Right click on the entry and select “Enable”

8. Also check that there is no Red “X” against your FireWire

interface, by checking under “IEEE 1394 Bus host
controllers” in this same list.

Check Plug-and-Play Detection

1. When the IF-FW/DM

II is correctly detected by

Windows XP, the plug-and-play icon will be shown in the
far right of the task bar.

2. Left Clicking on this will show “Safely Remove TASCAM

IF-FW/DM MKII”.

3. If there is no IF-FW/DM

II in the list, re-install the

drivers as described elsewhere in this manual.

Control Panel Check

1. From the Start Menu, select TASCAM->IFFWDMmkII-

>IFFWDMmkII Control Panel

2. If this entry is not in the menu, reinstall the drivers, using

the default installation directories and paths.

3. In the Control Panel, if the Device shows “No Device

Found” and the previous check is OK, the firmware in the
card may be incompatible with the version of the driver you
are using. Update to the latest driver and firmware from