Tascam IF-DM User Manual

 

8

•  DM-3200: The IF-FW/DM 

•  DM-4800: The IF-FW/DM 

•  The following installation must be done with the 

1.  Remove the five screws holding the blank plate or card 

currently installed in Slot 1 (or Slot 3 on the DM-4800) 
then remove the plate or card. 

2.  Insert the IF-FW/DM 

MK

II into the slot, making sure that 

the card edges slide into the white plastic guide inside the 
Slot.  Push it all the way in until it clicks and the card back 
plate is flush with the mixer’s back panel.  Excessive force 
is not required – if it doesn’t click in easily, remove it and 
start again with attention to the guides. 

3.  Replace the five screws to hold the card in place. 
4.  Turn on the mixer and navigate to the DIGITAL screen 

(LCD access button 2 with blue ALT LED lit), then select 
the SLOT tab (labeled SLOT 1-2 or SLOT 3-4 on the 
DM-4800), and check that the card is being recognized. If it 
shows “No Card”, re-check that the card is inserted 
correctly and the screws are fully tightened.  

•  The maximum FireWire cable length is 3 meters. 
1.  Connect one end of the provided FireWire cable to the IF-

FW/DM 

MK

II and the other end to an available FireWire 

port on your computer.  An inferior FireWire cable can 
negatively affect the performance of the system. 
•  Don’t connect the cable until the drivers have been