TANDBERG 8000 MXP User Manual

TANDBERG 8000 MXP 

14 

 

 

 
Monitor configuration 
 
Power up the system by using the power rail in the bottom of the base. Switch the system on by 
activating the power switch on the codec (located on the right hand side at the rear of the codec). 
A green light is shown (located in the center on the front of the codec). After the system has 
performed a self-test routine, the main menu will be displayed on the monitor. 
 
If the system does not start, check the following: 

ƒ  Check that the monitors are receiving power by looking at the right hand side. You should 

see a red light. The monitor must have power in order to be switched on by the codec. 

ƒ  Check that the codec has power and is switched on. 
ƒ  If there is still no signal on the monitor, press the 'Digital RGB (2)' button on the plasma 

remote control in order to select the 'Digital RGB input (DVI-D)' on the monitor. 

ƒ  Press the ‘Screen Size’ button on the plasma remote control in order to select which view 

type is to be used on the monitor. 

ƒ  Recommended view is FULL. This is a 16:9 mode that utilizes the full size of the monitor. 

Point the plasma remote control towards the lower right of each monitor (where the IR 
sensor is located) in order to switch mode. For the second monitor, this must also be 
done for the 'Digital RGB input (DVI-D)' : Press ‘Digital RGB (2)’ to select this input, then 
'Screen Size’ until the FULL view is shown.