Oreck WEDGE GUARD S063 Leaflet

• The alarm siren is very loud, never  

place the unit close to your ear, or 
allow children to play with this unit.

• Keep this manual for future reference.

1. Make sure the ON/OFF switch is in the  

“OFF” position. Remove the bottom plate 
of the unit and install a new 9 volt alkaline 
battery. Replace the bottom plate.

2. Place the unit on the floor close to the 

door without touching the door. (When  
the unit is turned on, do not place the 

unit against the door with the metal contact 
plate depressed or the alarm will sound.)

3. When the unit is switched to the “ON” 

position, it will wait approximately             
10 seconds then become active. The 
unit will now sound the alarm instantly 
when vibration is detected or if the 
metal contact plate is depressed.

4. When properly set, the unit will sound 

its alarm the moment the door is 
opened. In cases where there is an 
attempt to tamper with the unit from 
the outside, or push it out from under 
the door, the vibration sensor will 
sound the alarm immediately. 

5. To disarm the unit, simply slide the 

switch to the “OFF” position.

6. When the alarm volume becomes low, 

or the unit does not produce a normal 
strong alarm sound, replace the battery.

• Provides both contact and vibration 

alarm activation

• Wedge stop design prevents entry
• 9 volt battery power
• High output 120 dB alarm siren
• Simple ON/OFF switch operation

When utilized correctly, the "Wedge Guard"
can effectively increase your personal
safety in your home or business. However,
Oreck Corp. makes no warranties,
representations or guarantees regarding:
fitness for intended purpose; or its ability
to act as a deterrent to robbery, burglary or
other crime against your person or
property. Oreck Corp. expressly denies
responsibility for any losses, damages, or
injuries which may result from use.