Optibase MGW 2400 WMT User Manual

Chapter 2 

• Getting Started 

1.  Make sure that MGW 2400 is switched off and disconnect 

the power cable. 

2.  Remove the slot cover of the free slot in which you want to 

install an encoding module. 

3.  Firmly push the encoding module into the slot until you 

hear a click. This may require some force. A correctly 
inserted module should be completely flush with the rest of 
the unit, and must not protrude at all from the slot. 

4.  Screw the module to MGW 2400's rear panel. 

5.  Connect video and audio sources to the encoding module 

6.  Switch MGW 2400 on again. 

7.  To add a new channel and set channel parameters, refer to 

page 73. 

•  Do not install or remove encoding modules while running MGW 2400. 

This will cause damage to your MGW 2400 chassis and encoding 
modules. 

•  Avoid touching inside free slots as this may cause electrical hazards 

and damage your MGW 2400 unit. 

•  The Source LED only turns green if a video source is connected to the 

encoding module. If you only connect an audio source, the Source LED 
remains off.