Optibase MGW 2400 WMT User Manual

Chapter 2 

• Initial Configuration 

MGW 2400 requires a SCSI disk to save streams to file. MGW 
2400 is equipped with an Ultrawide SCSI port, which can 
connect to SCSI disks. 

1.  Format the SCSI disk on a separate PC in NTFS or FAT 

(

not

 FAT32) format. If you wish, you can divide the SCSI 

disk into several partitions. 

2.  Create folders on the SCSI disk using the DOS-Shell 

command MD. Copy clips to the SCSI disk. You may 
delete unused folders by using the DOS-Shell command 
RD. 

3.  Make sure that MGW 2400 is switched off. 

4.  Connect the accordingly prepared SCSI disk to MGW 

2400’s SCSI port. 

5.  Switch MGW 2400 on again; MGW 2400 is now ready to 

transmit prerecorded clips. The SCSI disk's default drive is 
drive D. Additional SCSI disk partitions are labeled in 
alphabetical order starting with drive E. 

For instructions on sharing SCSI disk partitions, refer to 
page 42. 

Remember that you may log on to MGW 2400 from the Configuration PC via 

RS-232 or from any computer on the network via Telnet.