Optoma HD20 User Manual

3

English

 

When the lamp 

reaches the end 

of its life, the 

projector will 

not turn back on 

until the lamp 

module has 

been replaced. 

To replace the 

lamp, follow 

the procedures 

listed under 

“Replacing the 

Lamp” section 

on pages 42-43.

 

 

 

Warning-  Do not look into the projector’s lens when the lamp is 

on. The bright light may hurt your eyes.

 

Warning-  To reduce the risk of fi re or electric shock, do not 

expose this projector to rain or moisture.

 

Warning-  Please do not open or disassemble the projector as 

this may cause electric shock.

 

Warning-  When replacing the lamp, please allow the unit to 

cool down. Follow instructions as described on pages 

42-43.

 

Warning-  This projector will detect the life of the lamp itself. 

Please be sure to change the lamp when it shows 

warning messages.

 

 Warning-  Reset the “Lamp Reset” function from the on-screen 

display “System | Lamp Settings” menu after 

replacing the lamp module (refer to page 33).

 

Warning-  When switching the projector off, please ensure 

the cooling cycle has been completed before 

disconnecting power. Allow 90 seconds for the 

projector to cool down.

 

Warning-  Do not use lens cap when projector is in operation.

 

Warning-  When the lamp is approaching the end of its lifetime, 

the message “Replacement suggested” will show on 

the screen. Please contact your local reseller or ser-

vice center to change the lamp as soon as possible.

N

ote

N

ote