Omega DP6-MLPS1 User Manual
INSTALLATION ENVIRONMENT
The unit should be installed in a location that does not exceed the
maximum operating temperature and provides good air circulation. Placing
the unit near devices that generate excessive heat should be avoided.
the unit near devices that generate excessive heat should be avoided.
Installation Procedure
The DP6-MLPS1 is shipped with all the necessary hardware to mount to
the rear of an installed DP63000x. Refer to the instructions that correspond
to your unit for proper installation.
to your unit for proper installation.
TROUBLESHOOTING
For further technical assistance, contact technical support at the appropriate
company numbers listed.
The user must remove the common and V+ screw terminals
on the rear of the DP63000x. Install the 3/16" hex drive
stand-offs into the common and V+ terminals. The
DP6-MLPS1 is then mounted to the stand-offs
using the supplied screws and square
washers. AC power can then be connected
to the terminal block of the DP6-MLPS1.
on the rear of the DP63000x. Install the 3/16" hex drive
stand-offs into the common and V+ terminals. The
DP6-MLPS1 is then mounted to the stand-offs
using the supplied screws and square
washers. AC power can then be connected
to the terminal block of the DP6-MLPS1.