Omega OMG-USB-SER-2 User Manual
Installation
OMG-USB-SER-2
Page 2
Installation
Operating System Installation
Choose Install Software at the beginning of the CD and install SeaCOM.
System Installation
The screen captures below are taken from a Windows 98 installation. Your
particular operating system may differ slightly from what is shown based on your
version of Windows.
particular operating system may differ slightly from what is shown based on your
version of Windows.
The OMG-USB-SER-2 can be connected to any upstream type “A” port either at
the PC host or an upstream hub. The OMG-USB-SER-2 is hot pluggable,
meaning there is no need to power down your computer prior to installation.
Connect the OMG-USB-SER-2 to an upstream host or hub.
the PC host or an upstream hub. The OMG-USB-SER-2 is hot pluggable,
meaning there is no need to power down your computer prior to installation.
Connect the OMG-USB-SER-2 to an upstream host or hub.
The New Hardware Found wizard will now proceed to locate the appropriate
drivers. These drivers were installed during the SeaCOM software setup
procedure. Once the drivers are found a new window will pop up indicating the
installation of each of the four new ports.
If you view the system’s Device Manager, you should have new “COM” ports in
the Ports (COM & LPT) Device Class. This is shown on the following page.
drivers. These drivers were installed during the SeaCOM software setup
procedure. Once the drivers are found a new window will pop up indicating the
installation of each of the four new ports.
If you view the system’s Device Manager, you should have new “COM” ports in
the Ports (COM & LPT) Device Class. This is shown on the following page.