Omni Group Step Top Wood Stove 57ST-ACC User Manual
Page 22
7038-159D
November 28, 2011
R
5700 Step Top Wood Stove Series ACC
5
Service Parts Replacement
A. Glass Replacement
1. Ensure that the fi re is out and the appliance is cool to the
touch.
2. Protect a table or counter top with padding or towels.
Protect your hands and wear gloves to prevent injury.
3. Remove the door with the broken glass by lifting the door
up and off of the hinges.
4. Lay door face down on a table or counter making sure the
handle hangs over the edge so the door lays fl at, on a soft
surface.
surface.
5. Remove the screws from each glass retainer and remove
the glass. (If screws are diffi cult to remove, soak with
penetrating oil fi rst).
penetrating oil fi rst).
6. Center the glass with edges evenly overlapping the open-
ing in the door, (i.e. same space top and bottom, left and
right sides).
right sides).
7. Replace the glass retainers. Be careful not to cross
thread the screws.
8. Tighten each retainer just a few turns until each is se-
cured. Check again for centering of glass in door frame.
Continue to tighten each retainer alternately, a few turns at
a time, until the glass is secure. DO NOT OVERTIGHTEN
- can cause glass to break.
Continue to tighten each retainer alternately, a few turns at
a time, until the glass is secure. DO NOT OVERTIGHTEN
- can cause glass to break.
9. Replace the door on the appliance.
Quadra-Fire appliances are equipped with ceramic super
heat-resistant glass, which can only be broken by impact or
misuse.
heat-resistant glass, which can only be broken by impact or
misuse.
WARNING! Risk of Fire or Injury!
Use only glass that is specifi ed in the manual, DO NOT
replace with any other material. Glass breakage will occur.
Use only glass that is specifi ed in the manual, DO NOT
replace with any other material. Glass breakage will occur.
CAUTION!
Handle glass with care.
• Inspect the gasket to ensure it is undamaged.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass & door assembly
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass & door assembly
removed.
• Do NOT operate with glass cracked, broken or
scratched.
B. Snap Disc Replacement
Magnet
Spade
Connectors
Snap Disc
Figure 22.1
1. Disconnect power supply. Locate the snap disc bracket
assembly at the bottom left rear corner of the appliance.
Figure 22.1.
Figure 22.1.
2. A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the snap
disc.
disc.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 22.2.
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
Figure 22.2
Snap Disc Location