Q-See QSDT16PCRC User Manual
44
45
CHAPTER 7 SYSTEM SETTINGS
Receiver's E-mail Address
Sender's SMTP
Sender's E-mail Address
Sender's User Name
Sender's Password
E-mail Subject
PICTURE 7-8
PICTURE 7-9
Auto Mail
Any of the alarm types can be configured to generate an alert e-mail but it is especially useful
when triggered by a motion detection event.
Any of the alarm types can be configured to generate an alert e-mail but it is especially useful
when triggered by a motion detection event.
NOTE! Before configuring the Auto Mail function, be sure to set up Motion
Detection.
Detection.
Click the Auto Mail icon on the left top side of alarm configuration page to enter the Auto
Mail Setup Interface.
Mail Setup Interface.
Users can set receiving and sending E-mail
SMTP server and address. The address
of receiver and sender can be the same.
However, this is not recommended as it can
overflow your e-mail account. Some free
e-mail providers also place a daily limit on
the number of e-mails sent and received by a
single account.
To test the settings, click Send Mail Test.
If all settings are okay, response ‘Message
Sent Successfully’ will pop up. If some
settings are wrong, a warning message will
pop up.
SMTP server and address. The address
of receiver and sender can be the same.
However, this is not recommended as it can
overflow your e-mail account. Some free
e-mail providers also place a daily limit on
the number of e-mails sent and received by a
single account.
To test the settings, click Send Mail Test.
If all settings are okay, response ‘Message
Sent Successfully’ will pop up. If some
settings are wrong, a warning message will
pop up.
If Attachment is enabled,then a picture of
what triggered the alarm will be sent to the
selected mailbox.
what triggered the alarm will be sent to the
selected mailbox.
PICTURE 7-10
PICTURE 7-11
PICTURE 7-12
NOTE! Only one picture will be attached for each alarm event.
7.3 E-MAP CONFIGURATION
E-map is used to show full geographic range covered by the whole monitoring system in the
form of map. An E-map features simple operation and direct display of status.
form of map. An E-map features simple operation and direct display of status.
NOTE! The system only supports bmp or jpg image format for E-Map files.
You will need to draw the floor plan of where
you want to install the cameras in a program
such as Paint or Photoshop and save it in
BMP or JPG format before using this feature.
Files will be proportionally scaled to 833x678
pixels when in use.
Click on Emap Edit and then right-click in
the demonstration map currently displayed.
Select Load Picture in the pop-up. Navigate
to where the image is stored on your
computer and open the file. The map will be
displayed in this interface, allowing you to
add the cameras to the map.
you want to install the cameras in a program
such as Paint or Photoshop and save it in
BMP or JPG format before using this feature.
Files will be proportionally scaled to 833x678
pixels when in use.
Click on Emap Edit and then right-click in
the demonstration map currently displayed.
Select Load Picture in the pop-up. Navigate
to where the image is stored on your
computer and open the file. The map will be
displayed in this interface, allowing you to
add the cameras to the map.
Drag the icon of a camera to the
corresponding position on the map, a
maximum of 32 cameras can be set
simultaneously, Click Change icon of camera
by right key to change icon or click Delete to
cancel a camera. After editing, right-click in
the map display area and select Save Map in
the pop-up to save the current map.
corresponding position on the map, a
maximum of 32 cameras can be set
simultaneously, Click Change icon of camera
by right key to change icon or click Delete to
cancel a camera. After editing, right-click in
the map display area and select Save Map in
the pop-up to save the current map.