Q-See QSDT16PCRC User Manual

CHAPTER 10

 MOBILE SUR

VEILLANCE

Click the PTZ icon to configure the PTZ camera’s controls

Protocol - Communication protocol of P.T.Z 

device

Port - Set the serial port number
Address - The communication address of 

P.T.Z device (ID number)

You should first enable the P.T.Z control function of selected camera and select a port number 
in 

P.T.Z Protocol Setup and then set corresponding parameters. You should get the Baud 

rate, Protocol and Address from your PTZ camera or its manual before proceeding.

Port - Set the port number
Baud rate - Set the P.T.Z device Baud rate, 
default value is 9600, used value must match 
Baud rate on PTZ control board
Data bits - The default value is 8, used value 
much match Baud rate on PTZ control board.
Parity - Odd and even parity bit, default Null, 
used value must match Baud rate on PTZ 
control board
Stop bits - Default value is 1, used value must 
match Baud rate on PTZ control board
Notice: Users should look into the P.T.Z 
device and get Baud rate, Protocol and 
Address first, and then set other values 
accordingly.
By clicking Copy To you can copy the setting of this channel to any other selected channel.

This video surveillance card supports mobile surveillance on smart phones and other devices 
running Android,Symbian and Windows Mobile Pro operating systems along with the iPad 
and iPhone on 3G networks. To access the card from these devices you must have first 
configured your card for remote access as shown beginning with Section 9.2 Configuring 
Router for Remote Access.

CHAPTER 10

Windows Mobile Pro 6.1 and 6.5 

STEP 1. Activate mobile network access on the 

mobile phone.

STEP 2. Run Internet Explorer
STEP 3. Input the DVR’s IP address or DDNS 

domain

STEP 4. You will be asked to download the 

software PCam. Click on the software name 
to open the download dialog pop-up

STEP 5. Click Yes to start downloading and 

installing.